Red Velvet Christmas Tree Cake Pops
A freshly baked cake looks sturdy in its pan, but once it’s crumbled, it turns into a bowl of soft red velvet crumbs. That change is exactly what makes these…
Tip: save now, cook later.A freshly baked cake looks sturdy in its pan, but once it’s crumbled, it turns into a bowl of soft red velvet crumbs. That change is exactly what makes these Red Velvet Christmas Tree Cake Pops possible: the cake can be pressed into little cones, then dipped in a smooth green shell. I like that the trees are shaped by hand, so they don’t need a special mold or a perfectly sharp edge to look festive.
The mixture needs just enough cream cheese, butter, and powdered sugar to hold its shape. I mix the binder through the crumbs until a handful stays together when pressed; adding more than that makes the centers heavier than they need to be. Give the shaped trees time to firm up in the refrigerator, and they’re much easier to dip without losing their pointed tops. Inside, you get a tender red velvet center under a crisp candy coating.

Kitchen Note
A tall microwave-safe container makes dipping these narrow trees much easier than a wide bowl does. Choose one deep enough to cover a tree without tipping it into the sides, then let the extra coating drip back into the container.
Save these Red Velvet Christmas Tree Cake Pops for a festive make-ahead treat with tender red velvet centers and a green candy shell.
Why the Cake Crumbs Should Hold Together, Not Feel Like Frosting
There’s a useful difference between a cake pop mixture that clumps when squeezed and one that feels sticky all the way through. For these trees, aim for the first. The cake already has a moist crumb from the oil and buttermilk, so the cream cheese mixture doesn’t need to turn it into a paste. When you press a small amount between your fingers, it should hold its shape; loose crumbs shouldn’t fall away.
If the mixture feels dense or greasy, it’s usually been worked past that point or has more binder than it needs. Crumble the cooled cake finely so the binder can spread through it evenly, then stop mixing once the whole bowl is moistened and presses together. That texture makes it possible to form a cone with a pointed top and a flat, wide base. The wide end gives the lollipop stick a secure place to go, while the pointed end makes the tree shape read clearly under its coating.
This is also why I don’t treat the binder like frosting and add it by feel. Use the listed amount, mix it through, and let the chilled mixture do the rest of the work. Firm cake centers are easier to lift and dip than soft ones, and they’re less likely to lose their shape while you decorate them.
What Gives These Red Velvet Trees Their Color, Crumb, and Coating

- Buttermilk and vinegar — Their acidity works with the baking soda and gives the cake its tender, lightly tangy red velvet crumb. I wouldn’t replace the buttermilk with plain milk without changing the formula; it would alter both the acidity and the texture.
- Red liquid food coloring — The liquid format gives the cake its vivid color while adding moisture to the batter. Gel coloring is more concentrated, so it isn’t a direct swap by the same volume; use liquid coloring for the color and texture intended here.
- Unsweetened cocoa powder — A small amount gives the cake a gentle cocoa note without making it taste like a full chocolate cake. Keep it unsweetened so it doesn’t add extra sugar or change the balance.
- Vegetable oil — Oil keeps the baked crumb soft, which helps it blend smoothly with the binder after crumbling. A neutral vegetable oil works well here; a strongly flavored oil would compete with the vanilla and cocoa.
- Cream cheese, butter, and powdered sugar — Together, these make a smooth binder that gives the cake crumbs enough cohesion to hold a tree shape. Let the cream cheese and butter soften before beating so the mixture doesn’t stay lumpy.
- Green candy melts and shortening — Candy melts set into the smooth outer shell these cake pops need. The shortening loosens the melted coating for dipping; ordinary chocolate isn’t a direct replacement because it behaves differently when melted and set.
Building the Trees So They Hold Their Shape Through Dipping
Bake the Red Velvet Cake
Heat the oven to 350°F and coat a 9×13-inch baking pan with nonstick cooking spray. Whisk the flour, sugar, baking soda, salt, and cocoa powder in a large bowl, then whisk the eggs, oil, buttermilk, food coloring, vanilla, and vinegar in a separate bowl. Stir the wet mixture into the dry ingredients just until smooth; mixing beyond that can make the cake tougher. Bake for 30 to 35 minutes, until a toothpick inserted in the center comes out clean, then cool the cake completely in the pan for about 1 hour.
Mix the Binder and Shape the Cones
Beat the softened cream cheese, butter, and powdered sugar until smooth. Crumble the cooled cake into a large bowl, add the binder, and mix until evenly moistened and able to hold together when pressed. Divide the mixture into 24 portions and shape each one into a tree-shaped cone about 1 1/2 inches tall. Set them on a baking sheet and refrigerate for 30 minutes, until firm; soft cones are harder to dip neatly.
Anchor Each Stick in the Cake
Melt the green candy melts with the shortening in a tall microwave-safe container at 50% power, using 30-second intervals and stirring between each one until smooth. Dip the tip of a lollipop stick about 1/2 inch into the coating, then insert it halfway into the wide end of a tree. Stand the cake pop upright and repeat with the remaining trees. Refrigerate them for 10 minutes so the coating around the sticks can set before dipping.
Dip and Decorate While the Shell Is Wet
Dip each tree into the melted coating, then let the extra drip back into the container. Press a yellow star onto the pointed top and add the red and green nonpareils while the coating is still wet; once the shell sets, the decorations won’t adhere as easily. Return the pops to the refrigerator for at least 20 minutes, until the coating is set. Handle them by the sticks once firm so the shell stays smooth.
Two Ways to Change the Shape or Finish
Make Green Red Velvet Cake Truffles
Skip the lollipop sticks and yellow star sprinkles, and shape the mixture into round balls instead of tree cones. Chill them until firm, dip each one in the same green candy coating, and finish with the nonpareils. The round shape is easier to coat, though it loses the tree silhouette and the crisp yellow star accent.
Give the Trees a Star-Only Finish
Leave off the red and green nonpareils and top each dipped tree with its yellow star only. The coating stays smooth and the bright star becomes the main decoration, with less crunch and color across the surface. Press the star into the coating before it sets.
Storage and Serving
- Refrigerator: Store the finished pops covered in the refrigerator and enjoy them within 3 to 4 days. The cake centers stay soft, while the nonpareils may lose a little crunch over time.
- Freezer: Freezing isn’t my first choice for decorated pops; condensation during thawing can make the candy shell and sprinkles tacky. Keep them refrigerated for the best finish.
- Serving: Serve them chilled. These are cake pops, not a dish to reheat; warming them can soften the candy coating.
Questions That Come Up While Making These Cake Pops

Red Velvet Christmas Tree Cake Pops
Ingredients
Equipment
Method
- Preheat the oven to 350°F and coat a 9x13-inch baking pan with nonstick cooking spray.
- Whisk the flour, granulated sugar, baking soda, fine salt, and unsweetened cocoa powder in a large bowl.
- Whisk the eggs, vegetable oil, buttermilk, red liquid food coloring, vanilla extract, and distilled white vinegar in a separate bowl.
- Stir the wet ingredients into the dry ingredients just until smooth.
- Pour the batter into the prepared pan and bake for 30 to 35 minutes, until a toothpick inserted in the center comes out clean.
- Cool the cake completely in the pan, about 1 hour.
- Beat the cream cheese, unsalted butter, and powdered sugar in a medium bowl until smooth.
- Crumble the cooled cake into a large bowl.
- Add the binder and mix until evenly moistened and the mixture holds together when pressed.
- Divide the mixture into 24 portions and shape each into a tree-shaped cone about 1 1/2 inches tall.
- Place the trees on a baking sheet and refrigerate for 30 minutes, until firm.
- Melt the green candy melts with the vegetable shortening in a tall, microwave-safe container at 50% power in 30-second intervals, stirring between intervals until smooth.
- Dip the tip of each lollipop stick about 1/2 inch into the melted coating.
- Insert each stick halfway into the wide end of a cake tree and stand the tree upright.
- Refrigerate for 10 minutes to set the sticks.
- Dip each tree into the coating, letting the excess drip back into the container.
- Press a yellow star-shaped sprinkle onto the top of each tree.
- Sprinkle each tree with red and green nonpareils while the coating is wet.
- Refrigerate the cake pops for at least 20 minutes, until the coating is set.
- Store them covered in the refrigerator.